New Handles Required: Pencil, Drill & Suitable Drill Bit 
  1. Decide roughly the desired position of the handle, and then hold the new handle on the surface in place of the exact location, use a pencil to mark the entry points of where the screw holes will go. Measure the spacing between the entry points to make sure its correct and you are happy with the positioning.
  2. Using your drill and drill bit, drill through the entry points
  3. Hold the handle over the newly formed holes and push your screws through the holes – using your hands at first to tighten in place, and then use a screwdriver to tighten all the way and fix the handle on firmly.
Replacing Old / Existing Handles
  1. Measure the distance between the 2 existing screw holes – check this measurement is the same as the hole centres on the new handle
  2. Remove the old handle by unscrewing the bolts
  3. Hold the handle over the holes and push your screws through the holes – using your hands at first to tighten in place, and then use a screwdriver to tighten all the way and fix the handle on firmly.